Lubrite Industries

Lubrite Industries is Manufacturer & exporter of Centralised lubrication systems like. Automatic Motorised lubrication units. deluxe lubrication units. electronis timers. electronic controllers. hand operated lubricator. pneumatic lubrications. Metering Cartridges. junction blocks. fittings(st. connectors, elbow connectors, banjo bolt assly, d/e connectors, clamps, tubinggs, planning/ installation of the system. Single Line Lubrication pumps. Manual grease, pumps. Pneumatic Grease pumps, Motorised Grease Pumps.Progreesive Block.Centralised Lubricatiobn Systems. Automatic Dual Line Lubrication Pump. Dual Line Dose Feeders.

Lubrite Industries is an independent 100% own manufacturing company which has achieved pioneer status in terms of technology and manufacturing capabilities.

Following kinds of tubes are available for single shot lubrication system:

1. Steel Tubes : These are zinc plated MS Seamless tubes with thickness of 0.89mm.

a. Steel Tube 6mm OD : Tube with 6mm OD is used for Main Line from pump to each junction blocks. It has smallest bending radius of 22mm and permissible pressure more than 200 kg/cm sq.

b.Steel Tube 4mm OD : Tube with 4mm OD is used for branch line from metering cartridges to end points. It has smallest bending radius of 8mm and permissible pressure more than 200 kg/ cm sq.

2. Nylon Tubes : These are semi transparent flexible tubes of material Nylon 6. These tubes are easy to work with. These are necessary for the points, which have motion. For better tube life, it can be protected with springs available with us. Thickness of tube in 1mm.

a. Nylon Tube 6mm OD : This tube has minimum bending radius of 70 mm and maximum permissible operating pressure 45kg/cm sq.

b. Nylon Tube 4mm OD : This tube has minimum bending radius of 50 mm and maximum permissible operating pressure 60kg/cm sq.

STEEL TUBINGS
Sr. No	Model	Description
1	ST6	Steel Tube 6mm OD
2	ST4	Steel Tube 4mm OD

NYLON TUBINGS
Sr. No	Model	Description
1	NT6	Nylon Tube 6mm OD
2	NT4	Nylon Tube 4mm OD

3. Hoses : Hoses are used for points where flexibility is a must and also mechanical strength is more such as sharp edges, area with movement of heavy components, chip falling area in machine tools etc. These hoses are made up of synthetic rubber with textile reinforcement.

a. Hoses with 6mm OD steel ends : Hoses are supplied with reusable type end fittings, with 6mm OD round ends of 25mm length. This hose has ID of 6.3 mm and has an operating pressure of 28 kg/cm sq.

b. Hoses with 4mm OD steel ends : Hoses are supplied with reusable type end fittings, with 4mm OD round ends of 22mm length. This hose has ID of 4.8 mm and has an operating pressure of 35 kg/cm sq.